![]() ![]() The exterior extrusion is now a new object. We select the entire object, then "Combine". Be careful between Shell Extrude and Extrude between the previous operation and this one as it will gives you problems later on like it happened to me. While the exterior surface are selected, you extrude the normals by. You press the "+" key to extend the selection. You keep the faces selected, you right click and select Shell Extrude and extrude them again by a small amount (0.05"). Bevel to the maximum then extrude normals by about. Select one edge then press G multiple times so it extends all around then L for loop until all is selected. Inverse the selection and delete all the vertical and horizontal edges. So I made an initial torus.įigure 1: Under Wings 3D, we start with a torus shape. I have to start from scratch and renew with this software. I checked my previous files and found that they were corrupted. Now is the time to correct this mistake and do something wild that cannot be done any other way than with a 3D printer. to create such parts but the results were too thin and never corrected the problem. Years ago, I made some parts with Wings 3D. I can use Blender to create something but I want to use another software that can creates very complex parts. For this assignement, I'm free to do something artistic. Individual Assignment: Additive designįor this week assignement, I have to design a part that cannot be made with substractively. The question is: Is 3D scanning as easy to use and can be a nice complement to 3D printing. It's other sibling, 3D scanning, is also a technology that people ask when they have a project in mind. 3D printing is the big selling point of setting up a FabLab in a library.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |